I'm trying to configure an HP network printer, but the printer configuration panel does not open, of the following message
I did not install any printer setup package, use only what is in the Rosa
Printer Setup in Rosa 2012.1 RC
Printer Setup in Rosa 2012.1 RC
Последний раз редактировалось linukiss 13 сен 2013, 02:24, всего редактировалось 1 раз.
Re: Printer Setup in pink 2012.1 RC
Mm, smth is wrong with the image attachment - I don't see anything...
Re: Printer Setup in pink 2012.1 RC
run system-config-printer...
Re: Printer Setup in pink 2012.1 RC
Hm, the printer configuration panel should launch system-config-printer, it is strange that it claims about 'printer' executable.linukiss писал(а):I'm trying to configure an HP network printer, but the printer configuration panel does not open, of the following message
I did not install any printer setup package, use only what is in the Rosa
Can you check the version of 'kcm-printer' package (show the output of "rpm -qi kcm-printer")? The freshest one has version 1.0 and release 7.
You can also check that system-config-printer tool is present and can be launched.
Re: Printer Setup in pink 2012.1 RC
after the last update everything is operating normally, sorry my bad english, I'm brazilian